Visara Master Console Center Scripting Guide Uživatelský manuál stáhnout pdf (Strana 221)

Chapter 6 Obsolete Material

Scripting Guide 221

MVSCOMMAND

Syntax:

MVSCOMMAND( %ObjID, $CmdArray, $Output Array, %ErrArray

$ErrorTextArray[, %PortID] [, $JobName] [, $Filter1] [, $Filter2] [,

$Filter3] [, %MvsMsgCount] [, %MvsResponseTime] ) ==>

%ReturnValue

Description:

Enters commands to MVS using the GW-MVS agent.

Action:

The commands in the $CmdArray parameter are issued to the OS

(LPAR) referenced by the ObjID parameter.

Parameters:

%ObjID. Numeric expression. The unique object identifier of the OS

to which to send the commands. Refer to Object ID on page 26 for more

information.

$CmdArray. Normal string array. The array of MVS commands to

execute on the target OS.

Note: Each command string must be less than eighty (80) characters

long.

$OutputArray. Associative array. Holds the text outputs of the

MVSCOMMANDS. The output is bounded by ===> and <===

characters, allowing the user to determine the output from each

command.

%ErrorArray. Normal integer array. Each command in $CmdArray

will have a corresponding element in %ErrorArray indicating the error

status of that command. A value of zero (0) indicates successful

submission to the host.

Note: A success (0) situation does not necessarily guarantee successful

processing. The command may have been submitted successfully, but

the action could not be completed on the host.

$ErrorTextArray. Normal string array. Each command in the

$CmdArray will have a corresponding string in $ErrorTextArray.

Each entry will give diagnostic information describing any problems

that occurred when submitting the command to the host.

%PortID. Numeric expression. Optional. The port to use to KEY the

commands to if the host service is unavailable. MVSCOMMAND will

automatically KEY all of the commands to the specified port when

necessary. The alternate route uses the KEY() command behind the

scenes. Specifying zero (0) indicates that an alternate route should not

be used if the service is unavailable, instead just returning an error

code. If not specified, zero (0) is the default.

$JobName. String expression. Optional. A filter to restrict output

from the submitted commands to only those which correspond to this

job name. The output is read using the QREAD() command.

$Filter1, 2, 3. String expression. Optional. These filters are used to

qualify which lines will be output from the submitted commands.

$Filter2 will be ignored unless $Filter1 is not empty. Similarly,

$Filter3 will be ignored unless $Filter2 is not empty.

Note: There is a 15-character limit on the size of each filter string.

$MvsMsgCount. Numeric expression. Optional. The maximum

number of messages (possibly filtered) that will return in the MVS-

1 2 ... 216 217 218 219 220 221 222 223 224 225 226 ... 261 262

Komentáře k této Příručce

Žádné komentáře

Visara Master Console Center Scripting Guide Uživatelský manuál Strana 221

Komentáře k této Příručce

Související produkty a manuály pro Počítačové příslušenství Visara Master Console Center Scripting Guide